| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN THE KEY OFF TO TURN MACHINE OFF AND LOCATE CHARGER PLUG ON THE BACK OF MACHINE AND PULL TO DISCONNECT IT.
|
| 2 |
|
REMOVE THE 6 SCREWS FROM THE BACK PANEL.
| Torx T30 |
|
|
| 3 |
|
REMOVE THE BACK PANEL
|
| 4 |
|
REMOVE THE VAC MOTOR GASKET. SET THE VAC MOTOR ON THE FLOOR AS IT WILL FALL OUT OF MACHINE.
|
| 5 |
|
LOCATE THE WHITE CONNECTOR BLOCK, REMOVE THE 2 BLACK WIRES FROM THE WHITE CONNECTOR. CUT OFF BAD SECTION OF WIRE, THEN INSERT TRIMMED WIRES BACK INTO CONNECTOR BLOCK. IF LIMITED LENGTH OF WIRE, CUT OUT BAD SECTION AND SPLICE IN NEW WIRING USING WIRE NUTS AND ELECTRICAL TAPE.
| Screwdriver-flat tip |
|
|
| 6 |
|
REVERSE STEPS 1 THRU 4 TO REASSEMBLE MACHINE.
|